Rockford Fosgate Subwoofers and Enclosures

Rockford Fosgate Subwoofers We Carry

We stock a hand-picked set of Rockford Fosgate drivers, chosen for the installs we build most, rather than the whole Rockford catalog. Both are shallow-mount 10s: the Punch P3S 10, rated at 300 watts RMS in 3.50 inches of mounting depth, and the Power T1 Slim 10, rated at 500 watts RMS with 15 mm of Xmax in 3.01 inches.

Dual 2 Ohm or Dual 4 Ohm

The P3S 10 comes as the P3SD2-10 and the P3SD4-10. Both share the basket, cone and power rating. The D2 wires to 1 or 4 ohm and has the lower Qts, so it stays tight in a small sealed box. The D4 wires to 2 or 8 ohm and wants a little more air, rewarding it with slightly deeper extension. The driver page carries Rockford's full parameters and our pre-calculated sealed results for both.

Power T1 Slim 10 for Sealed Boxes

The T1S2-10S is the sealed version of Rockford's Gen-2 T1 Slim, with a single 2 ohm coil and a neodymium motor. Rockford recommends 0.5 to 0.75 cubic feet sealed and does not recommend a port for the S version. Our down fire sealed T1 Slim enclosure shares its 9.13 inch cutout and stands 7 inches tall.

Where a Shallow Rockford Fits

Behind or under a truck seat, in a thin down-firing cabinet, or anywhere a full-depth motor will not clear. For more shallow options across brands, see our shallow mount subwoofers.

Enclosures Cut for Rockford Fosgate Drivers

Every Proline X cabinet on this page is cut for one specific Rockford Fosgate model, not a nominal size. Internal volume comes from that driver's published Thiele-Small parameters, and the cutout and mounting depth are cut direct fit, so match the model on the product page to the model on your woofer's label.

Punch, Prime and Power

Punch is the largest group: P1, P2 and P3, plus the P3 Shallow drivers in down fire and wedge cabinets. Prime covers the R2 and the R2 Shallow, and Power covers the T0 and T1, including the slim T1 in a low down-fire cabinet. Sizes run from 8 to 15 inch, sealed and ported.

Wedge or Down Fire

A wedge tapers at the back so it sits against a rear seat or trunk wall. A down fire cabinet lays flat and fires into the floor, which keeps the height low for trucks and hatch floors. Both are built on a 1.5 inch double baffle from Langboard Elite MDF in Tullahoma, Tennessee. Browse enclosure-only options in our Rockford Fosgate subwoofer box collection or every cabinet we build in the subwoofer box collection.

Powering a Rockford sub? Our monoblock amplifiers are the place to start.

Rockford Fosgate Questions

Which Rockford Fosgate subwoofers do you sell?

We carry a select few Rockford Fosgate drivers rather than the whole catalog. Right now that is the Punch P3S 10 shallow-mount subwoofer, in dual 2 ohm (P3SD2-10) and dual 4 ohm (P3SD4-10), and the Power T1 Slim 10 (T1S2-10S), the 2 ohm sealed-box version of the slim Power woofer. Any Rockford driver we add will appear on this page.

Do you build enclosures for other Rockford Fosgate subwoofers?

Yes. We cut Proline X enclosures for Punch P1, P2, P3 and P3 Shallow, Prime R2 and R2 Shallow, and Power T0 and T1 drivers, sealed and ported, in wedge and down fire shapes from 8 to 15 inch. Each cabinet is sized for one specific model. The full set is in our Rockford Fosgate subwoofer box collection.

Which enclosures fit the Rockford subwoofers you sell?

For the Punch P3S 10, three of ours: the down fire sealed 10 inch enclosure at 0.92 cubic feet net, which suits either coil, the down fire ported 10 inch enclosure tuned to 35 Hz, and the ported 10 inch wedge tuned to 36.5 Hz, both ported cabinets aligned for the P3SD4-10. For the Power T1 Slim 10 (T1S2-10S), our down fire sealed T1 Slim enclosure, which shares its 9.13 inch cutout.

Is the subwoofer included with the enclosure?

No. Our enclosures ship empty, and the Rockford Fosgate drivers are listed separately. Order the driver and the cabinet cut for it together and they arrive ready to wire.

Sealed or ported for a Rockford Fosgate subwoofer?

Sealed gives the smaller cabinet and tighter, more accurate bass, and it is usually the only option under a truck seat. Ported gives more output and deeper extension when you have the space. Each of our enclosure pages states the alignment it was cut to, and Rockford's own sealed and vented recommendations are on each driver page.