Wavtech linkRC

The LinkRC controls the output level of compatible WavTech components. Depending on the connected device, this can mean adjusting subwoofer volume, overall system level, or specific audio processing parameters. When connected to the LinkDQ, it primarily serves as a bass level controller accessible from the front of your vehicle.

The LinkRC installation is straightforward and can be completed in two ways. The standard installation uses two screws to mount under the dash, while the custom installation requires disassembling the housing to flush mount the knob through a hole in your dash or console. Basic car audio installation skills are sufficient for most installations.

The LinkRC comes with the control unit itself, a 5-meter (16.4ft) flat RJ45 cable for connecting to your WavTech component, and mounting hardware. The package includes everything needed for standard installation; custom installations may require additional materials depending on your specific setup.

The LinkRC is designed explicitly for WavTech components with RJ45 remote control ports. It is not compatible with equipment from other manufacturers unless they specifically support WavTech remote protocols, which is uncommon. For best results, use the LinkRC only with the compatible WavTech models listed in the specifications.

The LinkRC should be mounted in a location that is easily accessible to the driver but doesn't interfere with vehicle controls. Common mounting locations include under the dash, near the center console, or integrated into a custom panel. Ensure the 5-meter cable can reach from your mounting location to the connected WavTech component.

No, the LinkRC is a passive control device that does not process audio signals directly. It simply provides a convenient way to adjust the settings of your WavTech component. There is no degradation in sound quality when using the LinkRC as part of your audio system.

Each compatible WavTech component can only connect to one LinkRC at a time. However, in a system with multiple compatible WavTech components, you could use multiple LinkRC controllers, one for each component. This would allow independent control of different aspects of your audio system.